Specifications

Startup and General Configuration Summary
Starting and Navigating the Command Line Interface (CLI)
3-12 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
3.1.6.2 Logging in with a Default User Account
If this is the first time your are logging in to the Matrix E1 Series device, or if the default user
accounts have not been administratively changed, proceed as follows:
1. At the Username login prompt, enter one of the following default user names:
• ro for Read-Only access,
• rw for Read-Write access.
• admin for Super User access.
2. Press ENTER. The Password prompt displays.
3. Leave this string blank and press ENTER.The notice of authorization and the Matrix prompt
displays as shown in Figure 3-3.
NOTES: Display messages shown in Figure 3-2 about the device generating keys
pertain to Secure Shell (SSH) authentication. These lines will only display on the startup
screen the first time the device is powered on, or after NVRAM has been cleared.
Once the device has been configured for routing as described in Section 3.3, the
message “cannot open startup.cfg file” will no longer display. The startup.cfg file stores
the running configuration for the device when operating in router mode. This file does
not affect switch mode operation.