Specifications

Startup and General Configuration Summary
Command Defaults Descriptions
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-9
3.1.2 Command Defaults Descriptions
Each command description in this guide includes a section entitled “Command Defaults” which
contains different information than the factory default settings on the device as described in
Table 3-1 and Table 3-2. The command defaults section defines CLI behavior if the user enters a
command without optional parameters (indicated by square brackets [ ]). For commands without
optional parameters, the defaults section lists “None”. For commands with optional parameters, this
section describes how the CLI responds if the user opts to enter only the keywords of the command
syntax. Figure 3-1 provides an example.
Figure 3-1 Sample Command Default Description
3.1.3 CLI Command Modes
Each command description in this guide includes a section entitled “Command Mode” which states
whether the command is executable in Admin (Super User), Read-Write or Read-Only mode. Users
with Read-Only access will only be permitted to view Read-Only (show) commands. Users with
Read-Write access will be able to modify all modifiable parameters in set and show commands, as
well as view Read-Only commands. Administrators or Super Users will be allowed all Read-Write
and Read-Only privileges, and will be able to modify local user accounts.
Telnet port (IP) Set to port number 23.
TFTP server IP address Set to 0.0.0.0
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
show port status [port-string]
Command Defaults
If port-string is not specified, status information for all ports will
be displayed.
Table 3-2 Default Device Settings for Router Mode Operation (Continued)
Device Feature Default Setting