Specifications

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 8-11
Command Defaults
Data masks are required only for classification types requiring a second data-value.
For details, refer to Table 8-2.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to use Table 8-2 to create (and enable) classification rule number 1. This
rule will classify Ethernet II Type 1526 frames to VLAN 7 on the ports assigned to policy 1:
This shows how to set a classification rule that permits Ethernet II Type 1526 frames to be
forwarded on all VLANs:
This example shows how to use Table 8-2 to create (and enable) classification rule number 5. This
rule specifies that UDP frames from source port 45 will be filtered from VLAN 7 on ports assigned
to policy profile 8:
Table 8-2 provides the set policy classify data_values that can be entered for a particular
classification type, and the data_mask that can be entered for each classifier associated with that
parameter.
data_value Specifies the code for a predefined classifier. This value is
dependent on the classification type entered. Refer to
Table 8-2 for valid values for each classification type.
data_mask (Not required for most data values.) Specifies a value
dependent on the data-value entered. Refer to Table 8-2
for valid values for each classification type and data value.
Matrix>set policy classify 1 1 vlan 7 ether 1526
Matrix>set policy classify 2 2 vlan 4095 ether 1526
Matrix>set policy classify 8 5 vlan 7 udpportsource 45