Specifications

Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-27
6.2.1.19 set spantree bridgehellomode
Use this command to enable or disable bridge hello mode on the device.
set spantree bridgehellomode {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable single Spanning Tree hello mode on the device. Per-port hello
times can now be configured using the set spantree hellomode command as described in
Section 6.2.1.21:
enable Enables single Spanning Tree bridge hello mode.
disable Disables single Spanning Tree bridge hello mode, allowing
for the configuration of per-port hello times.
Matrix>set spantree bridgehellomode disable