Specifications

SNMP Command Set
Configuring SNMP Notification Parameters
5-62 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.7.5 set newaddrtrap
Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
set newaddrtrap [port-string] {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the new MAC address trap function on port ge.0.3:
NOTE: Transmitting SNMP new address traps requires that you configure the device
with the SNMP management station information using the set trap command as
described in Section 5.2.7.2.
port-string (Optional) Enables or disables the MAC address trap
function on specific port(s). If new source MAC
addresses are detected via these ports, an SNMP trap
message will be sent to the management station.
enable | disable Globally enables or disables the MAC address trap
function on all device ports.
Matrix>set newaddrtrap ge.0.3 enable