Specifications

Port Configuration Command Set
Disabling / Enabling Ports
4-14 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.2.2 Disabling / Enabling Ports
Purpose
To disable and re-enable one or more ports. By default, all ports are enabled at device startup. You
may need to disable ports in the event of network problems or to put ports “off-line” during certain
configuration procedures.
Commands
The commands needed to enable and disable ports are listed below and described in the associated
section as shown.
• set port disable (Section 4.2.2.1)
• set port enable (Section 4.2.2.2)