Specifications

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-89
3.2.6.13 set port ciscodp cos-ext
Use this command to set the CoS priority value for traffic received by a Cisco IP phone if the traffic
has been designated as untrusted. This command works in conjunction with the set port ciscodp
trust-ext command (Section 3.2.6.13), which designates devices as transmitting traffic through an
IP phone and into the Matrix switch as trusted or untrusted. When traffic has been set to untrusted
on a port, then it will be assigned the CoS priority value specified with this command.
set port ciscodp cos-ext port-string classify-value
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign priority 7 to untrusted traffic from port ge.0.5:
port-string Specifies the port(s) on which to set a CoS value. For a
detailed description of possible port-string values, refer to
Section 4.1.2.
classify-value Assigns a Class of Service to untrusted traffic. Valid values
are 0 - 7, with 0 given the highest priority.
NOTE: This command affects only the behavior of an attached Cisco IP phone and the
CiscoDP PDUs transmitted by the switch on behalf of the phone.
Matrix>set port ciscodp cos-ext ge.0.5 7