Specifications

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-87
3.2.6.11 set port ciscodp status
Use this command to set the status of the Cisco Discovery Protocol on one or more ports.
set port ciscodp status port-string {auto | disable | enable | passive}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the Cisco DP function on port ge.0.5:
NOTE: The Cisco Discovery Protocol must be globally enabled using the set ciscodp
status command as described in Section 3.2.6.5 before operational status can be set
on individual ports.
port-string Specifies the port(s) on which status will be set. For a
detailed description of possible port-string values, refer to
Section 4.1.2.
auto | disable |
enable | passive
Sets the port status as:
• auto enabled - will transmit only if a Cisco DP packet has
been received from another port.
• disabled - will not transmit or detect neighbors
• enabled - will transmit and will detect neighbors
• passive - will not transmit but will detect neighbors
Matrix>set port ciscodp ge.0.5 enable