Specifications

General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-85
Table 3-8 show port ciscodp info Output Details
Output What It Displays...
Port Port designation.
State Whether Cisco DP is enabled or disabled on this port.
Default state of disabled can be changed using the set port
ciscodp status command (Section 3.2.6.11).
VVID Whether a Voice VLAN ID has been set on this port. Default
of none can changed using the set port ciscodp vvid
command (Section 3.2.6.14).
#Neigh Number of neighboring Cisco devices detected on this port.
PDU-TX Number of Cisco DP PDUs transmitted on this port.
PDU-RX Number of Cisco DP PDUs received on this port.
CosExt Whether or not a Cisco DP Class of Service has been defined
for this port. Default of undefined can be changed using the
set port ciscodp cos-ext command (Section 3.2.6.13).
TrustExt Whether or not a trusted status has been defined for this port.
Default of undefined can be changed using the set port
ciscodp trust-ext command (Section 3.2.6.12).