Specifications

there may be multiple DFE modules in the chassis.
Firmware Version − Shows the current firmware version installed in the device. Following
the reset, the new firmware version will be displayed. Remember to click Refresh to update
the information in the table following the reset.
•
Device Status − The device's connection status (Contact or No Contact) and, therefore, its
ability to respond to SNMP requests.
•
Downloaded Image − The name of the image file that was downloaded.•
Download Status − The status of the download operation: Success (the operation succeeded),
Failure (the operation failed).
•
Reset Request Status − The status of the reset request.•
Message − A message relating to the status of the operation.•
TIP: Use the table options and tools to find, filter, sort, print, and export information in a table
and customize table settings. You can access the Table Tools through a right−mouse click on
a column heading or anywhere in the table body, or by clicking the Table Tools
button in the upper left corner of the table (if you have the row count column
displayed). For more information, see Table Tools.
Reset Type
Select the type of reset: Warm boot (restarts the device) or Cold boot (same as turning device power
off and on).
Elapsed Time
The amount of time in minutes:seconds since the reset operation started.
Start Button
Initiates the reset operation. Resets occur one at a time, continuing only after a device is fully booted.
After the reset operation is completed, you can click Refresh to update the device information in the
table.
Refresh Button
Once the reset operation has completed, use the Refresh button to update the device information in
the table.
Welcome to NetSight Inventory Manager Help
Reset Devices: Timed Reset Not Supported Window 436