Installation guide

Changing Trusted Access Gateway Settings
4-4 Enterasys Sentinel Trusted Access Gateway Setup
22. LaunchtheEnterasysSentinelTrustedAccessManagerfromyoursystem:
Start–>ProgramFiles–>EnterasysNetworks–>EnterasysSentinelTrustedAccess
Manager
23. IfthisisyourinitialcommissioningoftheMSM,selectGettingStartedfromtheHelp
pull‐downmenuforinformationonusingTrustedAccessManagerinyournetwork.
Ifyouareupgrading
yourTrustedAccessGatewaysoftware,besuretoenforcethe
TrustedAccessGateway(viaTrustedAccessManager)followingtheupgrade
operation.EnforcingwritesyourTrustedAccessManagerSecurityDomain
informationtothegateway.
Changing Trusted Access Gateway Settings
UsethesestepsinthissectionifyouneedtochangeyourTrustedAccessGatewaysettings
followingyourinitialcommissioning.
Changing Basic Network Configuration
TochangebasicnetworkconfigurationsettingssuchasMSMhostnameandIPaddress,
enterthefollowingcommandattheMSMCLI:
/opt/tag/dnetconfig/
Thiswillstartthenetworkconfigurationscriptandallowyoutomaketherequired
changes.Youmustrebootthesystemforthenewsettingstotakeeffect.
Changing the Management Server IP Address
TochangetheIPaddressofthemanagementserver,enterthefollowingcommandatthe
MSMCLI:
/opt/tag/configMgmtIP <IP address>
Then,startusingthenewmanagementserverbytyping:
tagctl restart
Enabling the SNMP Daemon
ToenabletheSNMPdaemon,enterthefollowingcommandattheMSMCLI:
/usr/postinstall/snmpconfig
Then,starttheSNMPdaemonbyentering:
/etc/rc.d/rc.net-snmp restart
IfyoureboottheMSM,theSNMPdaemonwillstartautomatically.