Installation guide

Installation
Enterasys Matrix Security Module Installation Guide 2-13
Installation
ToinstallaMini‐GBICwithanMT‐RJconnection,refertoFigure 2‐7;foranLC
connection,Figure 2‐8;orforanRJ45connection,Figure 2‐9,andthenperformthe
followingsteps:
1. HoldtheMini‐GBICwithitstopsidefacingupandits7‐pinedgeconnectorfacing
the
portslot.
2. CarefullyaligntheMini‐GBICwiththeportslot.
3. PushtheMini‐GBICintotheportslotuntiltheMini‐GBIC“clicks”andlocksinto
place.
Figure 2-7 Mini-GBIC with MT-RJ Connector
1 Mini-GBIC (MGBIC-MT01) 4 Port slot
2 Mini-GBIC, top side 5 Mini-GBIC, protective dust cover (Removed)
3 7-Pin edge connector (insertion side) 6 Release tab