Installation guide

Installation
Enterasys Matrix Security Module Installation Guide 2-9
7. ThiscompletestheMatrixSecurityModuleinstallation.
Toinstalltheexternalpowersupplyrequiredby7S‐NSTAG‐01and7S‐DSNSA7‐01,
proceedto“InstallingandSecuringtheExternalPowerSupply”onpage 2‐9.
ToinstallMini‐GBICsintotheMatrixSecurityModule,proceedto“Installing
OptionalMini‐GBICs”
onpage 2‐12.
Installing and Securing the External Power Supply
Thisinstallationprocedureappliestothe7S‐NSTAG‐01and7S‐DSNSA7‐01models.
Thepowersupplykitconsistsof:
•AnACpowercord
•AnAC‐to‐DCpoweradapterandDCconnector
•Onestandoff
•Oneplasticcabletie
RefertoFigure 2‐5onpage 2‐10andproceedasfollows:
1. InstalltheDFEmodule
containingtheMatrixSecurityModule(MSM)intothe
EnterasysMatrixswitchchassis,followingtheinstallationinstructionscontainedin
theDFEmodule’sInstallationGuide.
2. ConnecttheAC‐to‐DCpowersupplyadapter’sconnectorintotheMatrixSecurity
Module’sexternalpowerreceptacle.
3. ScrewthesuppliedstandoffintotheMatrixSecurityModulefaceplatescrew
hole.
4. Attachthesuppliedcabletietothestandoffwiththeexistingfaceplatescrew.