Installation guide

Installation
2-6 Installation
Installation When Internal Power Supplied by DFE Module
Thisinstallationprocedureappliestothe7S‐NSTAG‐01‐NPSand7S‐DSNSA7‐01NPS
models.
RefertoFigure 2‐3,andperformthefollowing steps:
1. PositiontheMatrixSecurityModule(MSM)soitsfrontpanelisundertheedgeofthe
DFEmodulefrontpanel.
2. CarefullyaligntheMatrixSecurityModuleconnectorswith
theDFEmainboard
connectors(includingtheDCpowersupplyconnector).Thenpressstraightdown
overtheconnectors,applyingpressureuntiltheyareproperlyseated.
Figure 2-3 Installing the 7S-NSTAG-01-NPS or 7S-DSNSA7-01NPS
1 Matrix Security Module (MSM) 4 DFE main board connectors 7 DFE power connector
2 DFE front panel 5 Saved screws (2) 8 MSM power connector
3 MSM connectors 6 Saved standoff