Installation guide

Installation
2-4 Installation
RefertoFigure 2‐1,andperformthefollowing steps:
1. Attachtheantistaticwriststrap(refertotheinstructionsontheantistaticwriststrap
package).
2. PlacetheDFEmoduleonanantistaticpadonasturdyflatsurface.
3. Removethesevenscrewsfasteningthesafetycovertothesevenstandoffsonthemain

board.Saveallscrewsforlaterusetoreinstallthesafetycover.
Figure 2-1 Removing the Safety Cover
1 Safety cover 3 Standoffs (7)
2 Screws (7) 4 Coverplate