Installation guide

LANVIEW Diagnostic LEDs
Enterasys Matrix Security Module Installation Guide 1-3
Figure 1-2 Module Front Panel – 7S-NSTAG-01 and 7S-DSNSA7-01
LANVIEW Diagnostic LEDs
TheMatrixSecurityModuleusesabuilt‐invisualdiagnosticandstatusmonitoring
systemcalledLANVIEW.TheLANVIEWLEDsallowquickobservationofthenetwork
statustoaidindiagnosingnetworkproblems.Referto“UsingLANVIEWDiagnostic
LEDs”onpage 2‐16forinformationaboutusingtheLEDsfortroubleshooting.
1 Mini-GBIC Gigabit port slots (2) 7 RS232 serial COM port
2 Gigabit ports link/activity LEDs 8 CPU power LED
3 USB port 9 CPU reset button
4 10/100 Ethernet port link LED 10 Hard drive activity LED
5 10/100 Ethernet port (see Note below) 11 10/100 Ethernet port activity LED
6 VGA port 12 External power supply connector
Note: The front panel Ethernet port is designed to connect to the DFE module. Do not
connect a PC directly to the Ethernet port. To connect your PC, use a repeater or a hub.
LINK
1
1
12V 5A
2
2
VGA
ACT
ETHERNET 10/100
CONSOLE
CPU/PWR
ACT
RESET
7S-DSNSAT-01
1
2 3 4 5 6 7 8
9
1011
12