Installation guide

Replacement Procedures

3-22 Matrix N5 PoE Chassis (7C105-P) Installation Guide

Figure 3-12 Reinstalling the Fan Assembly

5. Oncethetrayassemblyisinplace,tightenthefourslottedscrews(seeFigure 3‐12)to

securethetraytotheN5chassis.

6. Plugtheotherendofthe20Apowercordintoadedicated20A/120Vacreceptacle.

Setthe0/|powerswitchonthefrontpanelof

thepowersupplyto|.

7. Ensurethatallfansinthefanassemblyareoperatingproperly.The fanstatusLED

locatedatthetop‐leftfrontofthechassiswillturngreenwhenpowerisreceivedfrom

thepowersupplymodules.Formoreinf ormationonthepowersupplyLEDs(Power

and

Fan),referto“LANVIEWLEDs”onpage 2‐4.

Ifyouexperienceanyproblemswiththisinstallation,contactEnterasys Networksfor

assistance.

1 Captive Phillips-head screws (4) 3 Fan assembly

2 Fan assembly handles (2) 4 Self-aligning power connector