Installation guide

Replacement Procedures
Matrix N5 PoE Chassis (7C105-P) Installation Guide 3-21
Installing the Fan Assembly
Toreinstallthefanassembly,refertoFigure 3‐12andproceedasfollows:
1. LocatetheESDwriststrapshippedwiththeN5chassis.AttachtheESDwriststrapto
yourwristandplugthecablefromtheESDwriststrapintotheESDgrounding
receptacleattheupperrightcornerof
thechassis.
2. Holdthefanassemblybyitstwohandles.
3. Lineupthefanassemblywiththefourtappedscrewholesinthechassis.
4. Slidethefanassemblyintothechassisuntilthefaceplateofthetrayisflushwiththe
faceoftheN5chassis.Ifthereisanystrongresistance,
removethefanassemblyand
reinsertit.
Caution: In the following step, ensure that you do not force the fan assembly into place as
it may damage the self-aligning power/control connector in the chassis.
Precaución: En el siguiente paso, tenga cuidado de no colocar de manera forzada el
sistema de ventilación, porque puede dañar el conector de control de corriente con
autoalineación del chasis.