Installation guide

Replacement Procedures

3-20 Matrix N5 PoE Chassis (7C105-P) Installation Guide

Removing the Fan Assembly

Toremovethefanassembly,refertoFigure 3‐11andproceedasfollows:

1. LocatetheESDwriststrapshippedwiththeN5chassis.AttachtheESDwriststrapto

yourwristandplugthecablefromtheESDwriststrapintotheESDgrounding

receptacleattheupperfront‐rightcorner

ofthechassis.

2. UseaPhillipsscrewdrivertoloosenthefourcaptivePhillips‐headscrewslocatedat 

eachcornerofthefanassembly.

3. Slowlypullthefanassemblyawayfromtherearofthechassis.

Figure 3-11 Removing the Fan Assembly

1 Captive Phillips-head screws (4) 2 Fan assembly handles (2) 3 Fan Assembly