Installation guide

Connecting AC Power to N-POE PSMs
3-14 Matrix N5 PoE Chassis (7C105-P) Installation Guide
4. Ensurethatallfansinthefanassemblyareoperatingproperly.The fanstatusLED
locatedatthetop‐leftfrontofthechassiswillturngreenwhenpowerisreceivedfrom
thepowersupplymodules.Formoreinf ormationonthepowersupplyLEDs(Power
andFan),referto“LANVIEW
LEDs”onpage 2‐4.
5. IfN‐POEPSMshavebeeninstalled,proceedto“ConnectingACPowerto
N‐POE PSMs”.
Ifyouneedadditionalhelpwiththisinstallation,contactEnterasys Networksfor
assistance.
Connecting AC Power to N-POE PSMs
ACINLET1throughACINLET4atthefrontoftheN5chassisprovidepowertothe
N‐POE PSMsinslotsPOE1throughPOE4,respectively.AnACpowercordisshipped
witheachN‐POE PSM.
ToconnecttheACpowercord,refertoFigure 3‐8and proceedas
follows:
1. PlugtheACpowercordintotheappropriateACINLETconnector.Inthi sexample,
anN‐POE PSMisinstalledinslot POE1.Therefore,theACINLET1connectoris
used.
2. PlugtheotherendoftheACpowercordintoaseparatelyfusedACpoweroutletthat
meetsthepower
specificationsprovidedinAppendix A.
3. ChecktoseeiftheDCpowerLEDisgreenandtheACpowerLEDisoff.Otherwise,
referto“TroubleshootingtheN‐POEPSM”onpage 3‐15todeterminetheproblem.
4. Iftwoormorepowersupplieshavebeeninstalled,repeatsteps1through3
foreach
N‐POE PSM.
Ifyouneedadditionalhelpwiththisinstallation,contactEnterasysNetworks.Referto
“GettingHelp”onpage 1‐10 forinstructions.
Note: In Figure 3‐8thebaycoverisshowingthebaycoverremovedforclarity.It
isnotnecessarytoremovethebaycovertoobservetheLEDindications,because
theycanbeseenthroughthegrillinthebaycover.