Installation guide

Connecting AC Power to 7C205-1
Matrix N5 PoE Chassis (7C105-P) Installation Guide 3-13
Connecting AC Power to 7C205-1
Topowerupa7C205‐1,refertoFigure 3‐7and proceedasfollows:
1. Plugoneendofthepowercord(suppliedwiththepowersupply)intotheACpower
socketonthefrontpanelofthepowersupply.
Figure 3-7 Connecting the 20-Amp AC Power Cord to the 7C205-1
2. Plugtheotherendofthe20Apowercordintoa
dedicated20A/120Vacreceptacle.
PressthefrontpanelACpowerswitchto| (ON).
3. EnsurethatthePowerLEDisgreen.
Note: If two power supplies are installed, repeat the following procedure for each supply.
For proper redundancy using two 7C205-1 power supplies, the power cord from each
power supply must be connected to a dedicated 20-Ampere AC power circuit.
1 AC power cord 3 AC power source
2 AC INLET (1 power connector) 4 AC power switch
TOP - SLOT 5 BOTTOM - SLOT 1SLOT 4 SLOT 3 SLOT 2
POE 1 POE 3
POE 4POE 2
PS 1
PS 2
CAUTION: THIS UNIT MAY HAVE MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
FOUR (4) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
VORSICHT: DIESES GERÄT HAT MEHR ALS EINEN NETZANSSCHLUß. TRENNEN SIE VOR
WARTUNGSARBEITEN DIE 4 NETZANSCHLÜSSE VOM NETZ, UM ELEKTRISCHE SCHLÄGE ZU VERMEIDEN.
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
AC INLET 1 AC INLET 3
AC INLET 2 AC INLET 4
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
Â
À
Á
Ã