Installation guide

Installing the Chassis
3-12 Matrix N5 PoE Chassis (7C105-P) Installation Guide
5. Replacethebaycoverremovedinstep1.
6. Proceedto“ConnectingACPowerto7C205‐1”onpage 3‐13.
Figure 3-6 Installing the N-POE PSM
Caution: It is important to replace any bay cover removed during the installation to reduce
Electromagnetic Interference from the chassis.
Precaución: Para reducir la interferencia electromagnética del chasis, no olvide volver a
colocar todas las tapas de los compartimentos que haya quitado durante el proceso de
instalación.
Note: If you need to remove a N-POE PSM, refer to “Replacement Procedures” on
page 3-17 for instructions.
1 Enterasys Matrix N5 chassis 3 Power supply slot POE 1
2 N-POE PSM 4 Captive screw, Phillips head
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
TOP - SLOT 5 BOTTOM - SLOT 1SLOT 4 SLOT 3 SLOT 2
POE 1 POE 3
POE 4POE 2
PS 1
PS 2
CAUTION: THIS UNIT MAY HAVE MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
FOUR (4) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
VORSICHT: DIESES GERÄT HAT MEHR ALS EINEN NETZANSSCHLUß. TRENNEN SIE VOR
WARTUNGSARBEITEN DIE 4 NETZANSCHLÜSSE VOM NETZ, UM ELEKTRISCHE SCHLÄGE ZU VERMEIDEN.
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
AC INLET 1 AC INLET 3
AC INLET 2 AC INLET 4
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
Â
À
Ã
Á