Installation guide

Installing the Chassis
Matrix N5 PoE Chassis (7C105-P) Installation Guide 3-11
ToinstalltheN‐POE PSMs,proceedasfollows:
1. RefertoFigure 3‐5.UnscrewthetwoPhillips‐headcaptive‐coverscrewstoreleasethe
baycoverfromthechassisbaywhereyouplantoinstallanN‐POE PSM.(Inthi s
procedure,theleftbayisusedasanexample.)Removethebay
coverandsetitaside
fornow.
Figure 3-5 Removing a Chassis Bay Cover
2. RefertoFigure 3‐6.AligntheN‐POE PSMwithPOE1slotinsidebay1,thenslidethe
N‐POE PSMforwarduntiltheN‐POE PSMispluggedintothechassisconnectorand
completelyinsidethebay.Ifsignificantresistanceisencounteredbeforethe

N‐POE PSMreachestheendofitstravel,removeandreinsertthepowe rsupply.
3. FastentheN‐POE PSMtotheN5chassisusingthecaptivePhillips‐headscrewonthe
N‐POE PSMfrontpanel.
4. Repeatsteps2through3foreachadditionalN‐POE PSM.
Note: To reduce Electromagnetic Interference from the Enterasys Matrix N5 Chassis,
ensure that both bay covers are installed during operation.
Caution: In the following step, do not force the power supply into place. You could
damage the power supply and/or the chassis connector.
Precaución: En el siguiente paso, tenga cuidado de no colocar a fuerza la fuente de
poder en su sitio. Si lo hace, podría dañar tanto la fuente como el conector del chasis.
1 Captive screw, Phillips head (2) 2 Bay cover 3 Chassis bay (left)
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
À Á À Â
TOP - SLOT 5 BOTTOM - SLOT 1SLOT 4 SLOT 3 SLOT 2
POE 1 POE 3
POE 4POE 2
PS 1
PS 2
CAUTION: THIS UNIT MAY HAVE MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
FOUR (4) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
VORSICHT: DIESES GERÄT HAT MEHR ALS EINEN NETZANSSCHLUß. TRENNEN SIE VOR
WARTUNGSARBEITEN DIE 4 NETZANSCHLÜSSE VOM NETZ, UM ELEKTRISCHE SCHLÄGE ZU VERMEIDEN.
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
AC INLET 1 AC INLET 3
AC INLET 2 AC INLET 4
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz