Installation guide

Installing the Chassis
3-8 Matrix N5 PoE Chassis (7C105-P) Installation Guide
Figure 3-3 ESD Grounding Receptacle
Installing a 7C205-1Power Supply
Youmustinstallatleastone7C205‐1intheN5chassisforchassispower.Onepower
supplyprovidessufficientpowerforafullyloadedchassis,butasecondpowersupply
canbeinstalledtoprovidearedundant,loadsharingpowersource.Whenyoureceive
yourN5chassis,acoverplatewill
beinplaceoverpowersupplyslotPS2.
Whentwopowersuppliesareinstalled,theloadisevenlydistributed.Ifonepower
supplyfailsforanyreason,thesecondpowersupplyassumestheload.
ThepowersuppliesmustbeinstalledinthetwoslotslabeledPS1andPS2atthebottom
of
thechassis(Figure 3‐4).Ifyouintendtoinstallasinglepowersupply,itmustbeinstalled
intheslotlabeledPS1inthechassis.Alargeflatbladescrewdriverisneededtoinstallthe
powersupplies.
Toinstallthepowersupply,refertoFigure 3‐4andproceedas
follows:
1. SlidethepowersupplyintotheslotlabeledPS1,
asfollows:
a. Holdthepowersupplybyplacingonehandonthehandlelocatedonthefront
panelandusingtheotherhandtosupportthepowersupply.
b. Holdingthepowe rsupplyrightsideup,alignthepowersupplywiththebottom
oftheopeningPS1.
1 ESD grounding receptacle
FAN
STATUS
À
Caution: Forcing a misaligned power supply into place can damage the power supply
and/or the chassis backplane.
Precaución: Colocar de manera forzada una fuente de poder o no colocarla bien
alineada podría dañarla y/o maltratar el panel posterior del chasis.