Installation guide

Installing the Chassis
Matrix N5 PoE Chassis (7C105-P) Installation Guide 3-7
Figure 3-2 Rack Mounting the Enterasys Matrix N5 chassis
Attaching the Electrostatic Discharge Wrist Strap
TheElectrostaticDischarge(ESD)wriststrapmustbeattachedbeforehandlingthepower
supplies,fanassembly,andmodulesusedintheN5chassis.Inaddition,observeall
precautionswhenhandlingthesemodulestopreventdamagefromelectrostatic
discharge.
PlacetheESDwriststraponyourwristandplugtheotherend
intothegrounding
receptacle,atthetoprightcornerofthechassis,showninFi gure 3‐3onpage 3‐8.
1 Rack-mounting screws (5 per side)
ÀÀ
FAN
STATUS
0
50/60Hz
LINE:
100-125V~12A
200-240V~6A
POWER FAN
AC ON
TOP - SLOT 5 BOTTOM - SLOT 1SLOT 4 SLOT 3 SLOT 2
POE 1 POE 3
POE 4POE 2
PS 1
PS 2
CAUTION: THIS UNIT MAY HAVE MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
FOUR (6) POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK.
VORSICHT: DIESES GERÄT HAT MEHR ALS EINEN NETZANSSCHLUß. TRENNEN SIE VOR
WARTUNGSARBEITEN DIE 6 NETZANSCHLÜSSE VOM NETZ, UM ELEKTRISCHE SCHLÄGE ZU VERMEIDEN.
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
AC INLET 1 AC INLET 3
AC INLET 2 AC INLET 4
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz
100 - 125V ~ 15A
200 - 240V ~ 8A
50/60 Hz