Installation guide

Installing the Chassis
3-6 Matrix N5 PoE Chassis (7C105-P) Installation Guide
Installing the Chassis
TheMatrix N57C105‐Pchassiscanbeinstalledinastandard48.26‐centimeter(19‐inch)
equipmentrack.UptothreeN5chassis
chassis canbemountedinastandard7‐foothigh
cabinet.
Rack Mounting the Chassis
ToinstalltheMatrix N57C105‐Pchassisinarack,refertoFigure 3‐2andproceedas
follows:
1. Liftthechassisandalignthechassismountingholeswiththoseintherack.
2. Use10screws(5perside)providedwiththeequipmentracktosecurethechassisto
therack,starting
withthebottomholesandworkingtowardthetopofthechassis.
Note: Allow at least 60 centimeters (24 inches) or more clearance in front and rear of the
rack for chassis installation and maintenance.
Caution: Read Chapter 2 before completing the following procedure to ensure that all
installation guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea Chapter 2 para y
asegúrese de cumplir con todos los requisitos de instalación.
Note: In order to prevent a possible interference between the rack frame front and chassis
rack ears, the tapped rails may need to be adjusted such that they are recessed
approximately 2 inches behind the rack frame front. If the rack has a front door, this
distance may need to be slightly more depending on the door thickness.
Warning: To help prevent personal injury, at least two people are required to lift the
chassis into the rack.
Advertencia: Para ayudar a prevenir alguna lesión personal, al menos dos personas son
requeridas para levantar el chasis y meterlo al rack.
Warnhinweis: Zum Schutz vor körperlichen Schäden, sollten sie mit min. zwei Personen
das Chassis in das Rack heben.
Note: Refer to Table A-6 on page A-5 for recommended torque values to use when
installing the N5 chassis using standard threaded fastener machine screws and bolts.