Installation guide

Installation Site Requirement
3-2 Matrix N5 PoE Chassis (7C105-P) Installation Guide
Installation Site Requirement
TheMatrix N57C105‐PchassismustbeinstalledinaRestrictedAccessLocation(RAL).
Thislocationshouldonlybeaccessiblebypeoplethathavebeentrainedoraretechnically
competentenoughtobeawareofpotentialrisksofaccessingthehazardousareasofthe
chassis.Locationssuchasalockedwiring
closetorlockedcabinetmeetthisrequirement.
Required Tools
• Phillipsscrewdrivertoinstalltheunitintoarack,installN‐POE‐1200Wpower
supplies,cables,andreplacethefanassembly,ifnecessary.
•Largeflatbladescrewdrivertoinstallthe7C105‐Ppowersupply.
RefertoChapter 2fortheguidelinesthatmustbefollowedtoinstalltheEnterasysMatrix
N5.
Unpacking the Chassis
The7C105‐Pchassisispackedandshippedonaskid.Movetheskidtotheselected
installationsitebeforeunpackingthechassis.Examinetheoutsidepackagingforobvious
damage.Tounpackthe7C105‐Pchassis,refertoFigure 3‐1,whichincludesnumbersthat
correspondtothestepsbelow,and
proceedasfollows:
1. Cutthetwoshippingstrapsfasteningthecorrugatedboxtotheskid.
2. Liftandremovetheboxofftheskid.
Warning: Install the Enterasys Matrix N5 chassis in a Restricted Access Location only.
Access to the equipment by users must be restricted through the use of a tool or lock and
key or other means of security and is controlled by the authority responsible for the
location.
Advertencia: Instalar el chasis Enterasys Matrix N5 en un lugar de Acceso Restringido.
Acceso al equipo debe ser restringido mediante el uso de una herramienta o candado o
cualquier otro método de seguridad y debe ser controlado por el responsable del lugar.
Warnhinweis: Installieren Sie das N5 Chassis nur in einer zugangsgeschützten
Umgebung. Der Bereich zu den Komponenten sollte durch ein Schloß, einen Schlüssel
oder sonstigen Sicherungen geschützt und durch einen Verantwortlichen kontrolliert
werden.
Note: To facilitate installation, move the packed system to the intended installation site
before unpacking it.
Unpack the Enterasys Matrix N5 chassis components only as needed. Leave the
components in their respective shipping cartons until you are ready to install that
component. Save all shipping materials in the event that the chassis has to be repacked.