Installation guide

Memory Locations and Replacement Procedures

DFE-Platinum Series Hardware Installation Guide B-5

Figure B-5 Removing the Existing DIMM from 7G4282-49

3. RotatetheDRAMSIMMupwards,thenremoveitfromtheconnectorfingers.

Installing the DIMM on 7G4282-49

ToinstallaDIMM,refertoFigure B‐6andproceedasfollows:

1. InserttheDIMMdownbetweentheconnectorfingers.

2. PivottheDIMMdownwardsothetabsontheconnectorarmsalignwiththetwoDIMM

alignmentnotches.Withthetwoconnectorarmsspreadoutward,pushtheDIMMdown

betweentheconnector

arms.ThenreleasethetwoconnectorarmstolocktheDIMMinto

place.

Figure B-6 Installing the DIMM on 7G4282-49

1 Connector arms 2 DIMM 3 Connector fingers

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic

equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de

seguridad para evitar descargas de electricidad estática.

1 DIMM 3 Connector arms

2 Connector fingers 4 Alignment notches (2)