Installation guide

SIMM Replacement Procedure

B-8 Optional Installations and Mode Switch Bank Settings

2. Pivot the SIMM ➁ downward so the connector clips ➃ align with the two SIMM alignment

notches

➄ and the connector clips lock the SIMM into place.

Figure B-5 Installing the DRAM

3. Reconnect the device to the network as follows:

a. Reinstall the device into the rack if necessary.

b. Reinstall the top cover.

c. Reconnect the network cables to the device.

d. Reconnect both power cords from the rear of the chassis to the ac power outlets.

This completes the replacement of the DRAM SIMM.

➀

SIMM Alignment Notch

➂

Connector Fingers

➄

SIMM Alignment Notches (2)

➁

SIMM

➃

Connector Clips

3680-91