Installation guide

SIMM Replacement Procedure

Optional Installations and Mode Switch Bank Settings B-7

3. Push the release tabs ➀ away from the DRAM SIMM ➁, as shown in Figure B-4 and

simultaneously lift the DRAM SIMM enough to release it from the connector

➂.

4. Rotate the DRAM SIMM ➁ upwards as shown in Figure B-4 and remove it from the

connector ➂.

Figure B-4 Removing the Existing DRAM SIMM

B.4.3 Installing the DRAM SIMM

To install a DRAM SIMM, refer to Figure B-5 and proceed as follows:

1. With the SIMM alignment notch

➀ oriented as shown in Figure B-5, insert the SIMM ➁ down

between the connector fingers

➂.

➀

Release Tabs

➁

DRAM SIMM

➂

Connector

CAUTION: Observe all antistatic precautions when handling sensitive electronic

equipment.

3712_20