Installation guide

Removing the Chassis Cover
Optional Installations and Mode Switch Bank Settings B-3
b. Disconnect all network cables attached to the 1H582-xx.
2. If the 1H582-xx is rack mounted, remove it from the rack (refer to Chapter 3).
3. Use a Phillips screwdriver to remove the 12 screws
➀ attaching the cover ➁ to the chassis ➂.
(See Figure B-1.)
Figure B-1 Removing the Chassis Cover
ELECTRICAL HAZARD: TURN OFF THE 1H582-25/1H582-51 BY UNPLUGGING
THE POWER CORD FROM THE REAR OF THE CHASSIS.
AM HINTEN DES 1H582-25/1H582-51 STECHEI ABZIEHEN UM AUS ZU SCHALTEN.
APAGUE EL 1H582-25/1H582-51 DESENCHUFE EL CABLE DE LA UNIDAD.
TIP: Before performing step b, mark the cables connected to the 1H582-51 according to
their associated port numbers. This is recommended for ease of reinstallation.
➀
12 Cover Screws
➁
Coverplate
➂
1H582-51 Device (shown)
36802_11
2
1
4
6
8
10 12 14 16
3
5
7
9 11 13 15
18
17
20
22
24
26 28 30 32
19
21
23
25 27 29 31
34
33
36
38
40
42 44 46 48
35
37
39
41 43 45 47
Reset
Console
PWR
CPU
1H582-51
À
Á
(12)
Â