Installation guide

Completing the Installation

Hardware Installation 3-35

3.10 COMPLETING THE INSTALLATION

After installing the 1H582-25 or 1H582-51 and making the connections to the network, secure the

cables by running the cables along the strain-relief bracket and tying them to the strain-relief

bracket using cable ties.

Initial Logon to Device Management

You can now logon to the 1H582-25 or 1H582-51 via the console port and configure it using the

command line interface (CLI). To initially access device management from your local pc, terminal,

or modem connection, proceed as follows:

1. Enter rw (Read-Write) for Username.

2. At the Password prompt, press ENTER (RETURN).

For details on how to configure the 1H582-51 using the command line interface, refer to the

Matrix E1 (1G582-09 and 1H582-51) Configuration Guide. The CLI commands enable you to

initially set up and perform more involved switch management configurations.

After the initial configuration, you can also use WebView (Enterasys Networks’ embedded web

server) for configuration and management tasks, refer to the Matrix E1 (1G582-09 and 1H582-51)

WebView User’s Guide.

Modem Port Adapter Wiring and Signal Diagram

RJ45 DB25

Pin Conductor Pin Signal

1 Blue 2 Transmit (TX)

2 Orange 8 Data Carrier Detect (DCD)

4 Red 3 Receive

5 Green 7 Ground (GRD)

6 Yellow 20 Data Terminal Ready (DTR)

8 Gray 22 Ring Indicator

RJ45 Connector (Female)

Pins

045905

Pins

DB25 Connector (Male)

045907

131

2514