Installation guide

Connecting to Console Port for Local Management

Hardware Installation 3-31

2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB9 adapter (supplied

with the device).

3. Connect the RJ45-to-DB9 adapter to the communications port on the PC.

4. Turn on the PC and configure your VT emulation package with the following parameters:

When these parameters are set, the Startup screen will display. Proceed to Section 3.10 to complete

the installation.

Figure 3-20 Connecting an IBM PC or Compatible

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

➀

➂

UTP Cable with RJ45 Connectors

➁

RJ45-to-DB9 PC Adapter

➃

RJ45 Console Port

3680_01_30

Reset

Console

PWR

CPU

1H582-51