Installation guide

Installing the Device

3-20 Hardware Installation

3.7.4 Connecting Power

To connect the device to the power sources, refer to Figure 3-11 and proceed as follows:

1. Plug a power cord

➀ into each switch ac power receptacle ➁. To take advantage of redundancy

capabilities, each power cord must be plugged into a separate dedicated ac outlet

➂.

2. Plug the other end of each power cord

➀ into a dedicated grounded ac outlet ➂ as shown in

Figure 3-11.

Figure 3-11 1H582-51 Rear View

NOTE: The two power supplies in the device have automatic voltage sensing that

allows connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac,

1.25 A, 50/60 Hz.

NOTE: To take advantage of the load sharing and redundancy capabilities, each power

cord must be plugged into a separate dedicated ac outlet.

➀

AC Power Cords

➂

AC Power Outlets. Each outlet is on a separate circuit.

➁

AC Power Receptacles

3680_06