Installation guide

Installing Optional Mini-GBICs

3-14 Hardware Installation

To prepare and install a Mini-GBIC into the 1G-2MGBIC, proceed as follows:

Preparation

Before installing the Mini-GBIC, proceed as follows:

1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)

before removing the Mini-GBIC from the antistatic packaging.

2. Remove the Mini-GBIC from the packaging.

3. If there is a protective dust cover (see Figure 3-6,

➄) on the Mini-GBIC port, do not remove it

at this time.

Installation

To install a Mini-GBIC, refer to Figure 3-6 and proceed as follows:

1. Hold the Mini-GBIC

➀ with its top side ➁ facing up and its 7-pin edge connector ➂ facing the

1G-2MGBIC

port slot ➃ as shown in Figure 3-6.

2. Carefully align the Mini-GBIC

➀ with the 1G-2MGBIC port slot ➃.

3. Push the Mini-GBIC

➀ into the port slot ➃ until the Mini-GBIC “clicks” and locks into place.

Figure 3-6 Mini-GBIC Installation

➀ Mini-GBIC ➃

1G-2MGBIC Port Slot

➁ Mini-GBIC, Top Side ➄ Mini-GBIC, Protective Dust Cover

➂

7-Pin Edge Connector (insertion side)

➅

Locking Tab

36801_16

1G-2MGBIC