Installation guide
Installing Optional GBICs
3-8 Hardware Installation
Figure 3-3 Different Physical Styles of GBICs
After installing a GBIC, refer to Section 3.8 for details on connecting the GBIC to the network.
3.5.1 Side Clip GBICs
This section applies only to side clip GBICs.
Refer to Appendix C for cable specifications for the GBICs.
3.5.1.1 Installing the Side Clip GBIC
To install the GBICs, refer to Figure 3-4 and proceed as follows:
1. Attach the antistatic strap (refer to the instructions in the antistatic wrist strap package) before
removing the GBIC from the antistatic packaging.
2. Remove the GBIC from the packaging.
➀
Side Clip
➁
Locking Bar
CAUTION: Damage can result to the GBIC and host 1G-2GBIC if the directions in this
section are not followed carefully.
CAUTION: The GBIC, 1G-2GBIC, and 1H582-xx are sensitive to static discharges. Use
an antistatic wrist strap and observe all static precautions during this procedure. Failure
to do so could result in damage to the GBIC, 1G-2GBIC, and the host device. Always
leave the GBIC in the antistatic bag in which it was shipped or an equivalent antistatic
container until ready to install it.
25492_04
RX
TX
BA
Á
À