Installation guide

Installing an Optional Ethernet Expansion Module

3-6 Hardware Installation

Figure 3-2 Installing the Ethernet Expansion Module

This completes the Ethernet expansion module installation. If you installed an Ethernet expansion

module that accepts GBICs, proceed to Section 3.5 for installation instructions. Otherwise, proceed

to Section 3.7 to continue installing the device.

3.4.3 Removing the Ethernet Expansion Module

To remove the Ethernet expansion module, refer back to Figure 3-2 and proceed as follows:

➀

Levers

➄

Rear Connectors

➁

Ethernet Expansion Module

➅

Captive Screws (2)

➂

Guides

➆

Front Panel

➃

Option Slot

CAUTION: The expansion modules are NOT hot-swappable. The switch must be

powered down before the expansion modules are installed or removed. Hot-swapping

the expansion modules while the switch is powered on could cause the device to stop

forwarding frames.

3737_02

1G154-09

COM

RESET

CPU

PWR

1G-2GBIC