Installation guide

Installing an Optional Ethernet Expansion Module
Hardware Installation 3-5
Figure 3-1 Removing the Front Panel Coverplate
3.4.2 Installing an Ethernet Expansion Module
Refer to Figure 3-2 and proceed as follows:
1. Pull the two Ethernet expansion module levers
➀ outward to their maximum travel.
2. Align the Ethernet expansion module
➁ with the guides ➂ inside the option slot ➃, and push
the module into the slot until the levers
➀ just begin to move back towards each other.
3. Rotate levers
➀ back to their center positions to fully seat the module rear connectors ➄.
4. Tighten the two captive screws
➅ to secure the Ethernet expansion module ➁ to the device front
panel
➆.
➀
1H582-51 shown
➂
Coverplate
➁
Coverplate Captive Screws (2)
➃
Front Panel
CAUTION: The expansion modules are NOT hot-swappable. The switch must be
powered down before the expansion modules are installed or removed. Hot-swapping
the expansion modules while the switch is powered on could cause the device to stop
forwarding frames.
CAUTION: If the expansion module does not insert smoothly when performing steps 2
or 3, do not force into place. Remove the expansion module and repeat the steps.
2
1
4
6
8
10 12 14 16
3
5
7
9 11 13 15
18
17
20
22
24
26 28 30 32
19
21
23
25 27 29 31
34
33
36
38
40
42 44 46 48
35
37
39
41 43 45 47
Reset
Console
Console
PWR
CPU
1H582-51
3680_25
À
Á
Â
Ã
Á