Installation guide

Hardware Installation 3-1

Hardware Installation

This chapter provides the instructions required to install the 1H582-xx. Follow the order of the

sections as listed below to correctly install the device.

• Unpacking the device (Section 3.2)

• Installing options (Section 3.3)

• Installing the device (on a shelf or tabletop, or into a standard rack) (Section 3.7)

• Connecting to the network (Section 3.8)

• Completing the installation (Section 3.10)

3.1 REQUIRED TOOLS

A Phillips screwdriver is required to install the device into a rack and to install an Ethernet

expansion module.

ELECTRICAL HAZARD: Only qualified personnel should install the 1H582-xx.

NOTE: Read the Release Notes shipped with the device to check for any exceptions to

the supported features and operation documented in this guide.