Installation guide

Gaining Access to Memory Modules

B-12 Mode Switch Settings and Option Installations

Figure B-8 Installing the DIMM

Installing the Network Expansion Module (NEM)

RefertoFigure B‐9andproceedas follows:

1. Positionthenetworkexpansionmodulesoitsfrontpanelisundertheedgeofthe

DFE modulefrontpanel.

2. Alignthetwonetworkexpansionmoduleconnectorswiththemainboardconnectors.

Thenpressstraightdownoverthetwonetworkexpansionmoduleconnectors,

applyingpressureuntil

theyareproperlyseated.

1 DIMM 3 Connector arms

2 Connector fingers 4 Alignment notches (2)