Installation guide

Installation Site Requirement
3-2 Installation
Installation Site Requirement
TheDFE modulesmustbeinstalledinaMatrixE7,N3,N5,orN7chassislocatedina
RestrictedAccessLocation(RAL).Thislocationshouldonlybeaccessiblebypeoplethat
havebeentrainedoraretechnicallycompetentenoughtobeawareofpotentialrisksof
accessingthehazardousareasofthe
chassis.Locationssuchasalockedwiringclosetor
lockedcabinetmeetthisrequirement.
Required Tools
APhillipsscrewdriverisrequiredtoinstallanoptionalnetworkexpan sionmoduleinto
the7G428549.
Unpacking the DFE Module
UnpacktheDFE moduleasfollows:
1. OpentheboxandremovethepackingmaterialprotectingtheDFE module.
2. VerifythecontentsofthecartonaslistedinTable 31.
3. Removethetapesealonthenonconductivebagtoremovethemodule.
4. Performavisualinspectionofthemoduleforanysignsofphysical
damage.Contact
Enterasys Networksifthereareanysignsofdamage.RefertoGettingHelpon
page xviiifordetails.
Warning: Install this module in a Matrix E7, N3, N5, or N7 chassis that has been installed
in a Restricted Access Location only. Access to the equipment by users must be restricted
through the use of a tool or lock and key or other means of security and is controlled by
the authority responsible for the location.
Advertencia: Instalar este modulo en un Matrix E7, N3, N5, o N7 que ha sido localizado
en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem E7, N3, N5, oder N7 Chassis,
wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich zu den
Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen Sicherungen
geschützt und durch einen Verantwortlichen kontrolliert werden.
Table 3-1 Contents of DFE Module Carton
Item Quantity
DFE module (either the 7G4285-49 or the 7G4205-72) 1
This Installation Guide 1
Customer Release Notes 1