Installation guide

DFE-Platinum Series Hardware Installation Guide 3-1
3
Installation
Thischapterprovidestheinstructionstoinstallthe7G4285‐49and7G4205‐72
DFE modules.Followtheorderofthesectionslistedbelowtocorrectlyinstallthe
DFE modules.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE modules to check for any exceptions to the
supported features and operation documented in this guide.
For information about... Refer to page...
Installation Site Requirement 3-2
Required Tools 3-2
Unpacking the DFE Module 3-2
Installing an Optional Network Expansion Module (NEM) 3-3
DFE Module Placement and Installation Rules 3-3
Preparing to Install into a Chassis 3-6
Connecting 48 Vdc Power for PoE Operation 3-12
Connecting to the Network 3-12
Connecting to COM Port for Local Management 3-18
Completing the Installation 3-24