Installation guide

Memory Locations and Replacement Procedures

B-10 Mode Switch Bank Settings and Optional Installations

3. Pull the DIMM straight up and remove it from the connector.

Installing the DIMM on 4H4203-72

To install a DIMM, refer to Figure B-12 and proceed as follows:

1. Push the connector arms away from the DIMM enough to insert the DIMM into the

connector fingers.

2. Insert the DIMM straight down between the connector fingers enough for the tabs on

the connector arms to align with the two DIMM alignment notches.

3. Push the DIMM down into the connector fingers. Then rotate the two connector arms

toward the DIMM to lock it into place.

Figure B-11 Removing Existing DIMM from 4H4203-72

1 Connector arms 2 DIMM 3 Connector

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.