Installation guide

Memory Locations and Replacement Procedures

Matrix DFE-Gold Series Modules Installation Guide B-9

Removing the DIMM from 4H4203-72

To remove the existing DIMM, proceed as follows:

1. Locate the DIMM connector on the main PC board. Refer back to Figure B-6.

2. Push the connector arms away from the DIMM, as shown in Figure B-11, enough to

release the DIMM from the connector.

Figure B-10 Installing the DIMM on 4H4282-49

or 4H4283-49

1 Connector arms 3 Connector

2 DIMM memory module 4 DIMM alignment notches (2)

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.