Installation guide

Memory Locations and Replacement Procedures

B-8 Mode Switch Bank Settings and Optional Installations

2. Refer to Figure B-9. Push the connector arms away from the memory module to

release it from the connector.

3. Remove the module from the connector.

Installing the DIMM on 4H4282-49 or 4H4283-49

To install the memory module, refer to Figure B-10 and proceed as follows:

1. With the connector arms set in the open position, insert the memory module between

the connector fingers and push the memory module into the connector until the tabs

on the two connector arms pull in towards the DIMM alignment notches.

2. Push the DIMM further into the connector until the two DIMM alignment notches

and the tabs on the two connector arms lock the DIMM into place.

Note: The ejector arms on this connector are not spring loaded, so they will remain in the

open position until manually closed.

Figure B-9 Removing the Existing DIMM from 4H4282-49 or 4H4283-49

1 Connector arms 2 Memory module 3 Connector

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.