Installation guide
Installing Module into Matrix N3 Chassis
Matrix DFE-Gold Series Modules Installation Guide 3-13
Installing Module into Matrix N3 Chassis
To install a DFE-Gold module, refer to Figure 3-7 and use the same procedure described
in “Installing Module into a Matrix E7 or Matrix N7 Chassis” on page 3-10. As with the E7
and N7 chassis, 7xxxxx modules cannot be installed with the 4xxxxx modules.
Caution: Failure to observe static safety precautions could cause damage to the
DFE-Gold module. Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the DFE-Gold module. Sharp objects
contacting the board or components can cause damage.
Caution: When setting the locking levers to the closed position, do not try to force the
locking levers to the point that they touch the face of the front panel. Forcing the locking
levers to this point could damage the module and chassis.
Figure 3-7 Installing Module into Matrix N3 Chassis
1 Card guides 5 Upper locking tab (shown in closed position)
2 Slot 1 (Top slot is slot 3.) 6 Lower locking tab (shown in closed position)
3 Module card 7 FTM2 backplane and power connectors
4 Metal back panel
➂
➃
➄
➅
➀
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
➁
➆
47X
1X
G
R
O
U
P
4
G
R
O
U
P
1
G
R
O
U
P
2
G
R
O
U
P
3
11X
13X
23X
25X
35X
37X
RESET
COM
CPUMGMT
GROUP
SELECT
GROUP
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
4H4282-49
FAST ENET
DFE