Installation guide

Installing Optional Ethernet Interface Module
3-4 Installation
5. Use the two saved coverplate screws to fasten the interface module to the
DFE-Gold module front panel. Do not tighten the two coverplate screws at this time.
6. Use the screw removed from the main board and fasten the interface module to the
standoff. Tighten the screw.
7. Tighten the two coverplate screws.
8. This completes the interface module installation. To install Mini-GBICs into the
interface module, proceed to “Installing an Optional Mini-GBIC” on page 3-5.
Otherwise, proceed to “Installation Rules” on page 3-8 to install the module into the
chassis.
Figure 3-2 Installing the Ethernet Interface Module
1 Screw (1) 4 Standoff 7 Interface module connectors
2 Screw hole 5 Optional interface module 8 Main board connectors
3 Main board 6 DFE-Gold module
front panel 9 Coverplate screws (2)
➀
➃
➄
➁
➂
1
2
1
2
3
4
5
6
➅
➆
➇
➈
4H4282-49
F
AST ENET
DFE