Installation guide

Matrix DFE-Gold Series Modules Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the 4H4282-49, 4H4283-49, 4H4203-72,
4H4202-72, and 4H4284-49
DFE-Gold modules and optional interface module
7G-6MGBIC.
A Phillips screwdriver is required to install an optional interface module into the
4H4282-49, 4H4283-49, or 4H4284-49. Follow the order of the sections listed below to
correctly install the modules.
• Unpacking the DFE-Gold Module (page 3-2)
• Installing Optional Ethernet Interface Module (page 3-2)
• Installing an Optional Mini-GBIC (page 3-5)
• Installation Rules (page 3-8)
• Installing Module into a Matrix E7 or Matrix N7 Chassis (page 3-10)
• Installing Module into Matrix N3 Chassis (page 3-13)
• Connecting to the Network (page 3-14)
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE-Gold module to check for any exceptions to the
supported features and operation documented in this guide.
Note: Unless otherwise noted, the installation instructions apply to all DFE-Gold modules.