Installation guide

How to Use This Guide
Matrix DFE Series Modules Installation Guide xv
How to Use This Guide
Related Documents
The manuals listed below can be obtained from the World Wide Web in Adobe Acrobat
Portable Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
• Matrix DFE-Gold Series Configuration Guide provides information on how to use the
Command Line Interface to set up and manage the DFE-Gold modules.
• Cabling Guide provides information on dB loss and cable specifications.
Unlike the Matrix DFE-Gold Series Configuration Guide, the Cabling Guide is not listed
alphabetically on the web site. Instead, it is listed under the Overview Guides link.
For... Refer to...
An overview of the DFE-Gold modules and
instructions to obtain technical support from
Enterasys Networks
Chapter 1, Introduction
Network requirements that must be met before
installing the DFE-Gold modules
Chapter 2, Network Requirements
Instructions to install the DFE-Gold module
hardware and optional interface card
Chapter 3, Installation
Troubleshooting installation problems and
diagnosing network/operational problems using the
LANVIEW LEDs
Chapter 4, Troubleshooting
Specifications, environmental requirements, and
physical properties of the DFE-Gold modules, the
optional 7G-6MGBIC Ethernet interface module,
and Mini-GBIC interface cards
Appendix A, Specifications
Instructions to set the mode switches when
necessary and remove and replace DIMM and
DRAM SIMM memory
Appendix B, Mode Switch Bank Settings
and Optional Installations