Installation guide

Installing an Optional PoE Module in the G3G124-24 Switch
2-24 Installation
Figure 2-12 Screw and Coverplate Removal for Removing the G3G124-24 Cover
2. UsingaPhillipsscrewdriverandacounter‐clockwisemotion,removeallnecessaryscrews.
3. RetainscrewsandtheCompactFlashcoverplateinasecurelocationuntilthePoEmodule
installationiscompleteandyouarereadytoreinstalltheswitchcover.
4. Liftthecoverofftheswitch.
Installing the PoE Module
Onceyouhavecompletedthestepsdescribedin“RemovingtheSwitchCover”onpage 2‐23,you
caninstallthePoEmodule inthebase switch.Installationinstructionsandthelocationof
standoffsandPoE‐to‐motherboardconnections(behindtheports)arethesameaspreviously
describedforinstallingPoEon
theG3G‐24TXIOM.
ToinstallanoptionalPoEmoduleintheG‐Seriesbaseswitch:
1. UsingFigure 2 ‐3onpage 2‐11asaguidelineforlocatingstandoffsonthebaseswitch,follow
theprocedurein“InstallinganOptionalPoEModuleontheG3G‐24TXIOM”onpage 2‐10.
2. Replace
theswitchcoverandCompactFlashcoverplateandsecureallscrews.
3. Reinstallallnecessarycomponentsintheswitch.